Check_Point
156-115.80 · Question #18
You issued the command "set ipv6-state on" in order to enable IPv6 protocol on a Security Gateway. The command was executed successfully. After reboot you notice that IPv6 protocol is not enabled…
Sign in or unlock 156-115.80 to reveal the answer and full explanation for question #18. The question stem and answer options stay visible for context.
Core R80 Architecture and Management
Question
You issued the command "set ipv6-state on" in order to enable IPv6 protocol on a Security Gateway. The command was executed successfully. After reboot you notice that IPv6 protocol is not enabled. What do you do to permanently enable IPv6 protocol?
Options
- AIssue "set ipv6-state on" again; Save configuration and reboot
- BYou need to modify Gateway Properties in SmartConsole and install policy in order to enable IPv6
- CYou need to set "ipv6_state" parameter in $FWDIR/boot/modules/fwkern.conf and reboot
- DYou need to install a valid license to use IPv6 protocol
Unlock 156-115.80 to see the answer
You've previewed enough free 156-115.80 questions. Unlock 156-115.80 for full answers, explanations, the timed quiz mode, progress tracking, and the master PDF. Question stem and options stay visible so you can still see what's on the exam.
Topics
#IPv6 configuration#persistent settings#Gaia OS#Security Gateway