Check_Point
156-115.77 · Question #231
You are configuring OSPF on your Secure Platform firewall. You are in expert mode and run the commands: interface vt-Gateway_C IP ospf 1 area 0.0.0.0 exit When you run show running-config you do not…
The correct answer is D. You did not run command enable before you exited. See the full explanation below for the reasoning.
Question
You are configuring OSPF on your Secure Platform firewall. You are in expert mode and run the commands:
interface vt-Gateway_C IP ospf 1 area 0.0.0.0 exit When you run show running-config you do not see your OSPF configuration listed Why?
Options
- AYou did not run command save running config before you exited.
- BYou should not have moved to expert mode to make these configurations.
- CYou did not run command save configuration before you exited.
- DYou did not run command enable before you exited.
How the community answered
(34 responses)- A9% (3)
- B12% (4)
- C3% (1)
- D76% (26)
Community Discussion
No community discussion yet for this question.