Check_Point
156-115.77 · Question #203
In a ClusterXL that uses IPV6 Address, how do you configure the sync interface?
The correct answer is A. You must configure synchronization interfaces with an IPv4 address only. See the full explanation below for the reasoning.
Question
In a ClusterXL that uses IPV6 Address, how do you configure the sync interface?
Options
- AYou must configure synchronization interfaces with an IPv4 address only.
- BIf an interface does not require IPv6, only the IPv4 definition address is necessary.
- CAll interfaces configured with an IPv6 address must also have a corresponding IPv4 address.
- DYou must configure synchronization interfaces with an IPv6 address only.
How the community answered
(30 responses)- A73% (22)
- B17% (5)
- C3% (1)
- D7% (2)
Community Discussion
No community discussion yet for this question.