Brocade
150-820 · Question #152
Referring to the exhibit, what is the cause of the error when applying a port channel to an interface? sw0(conf-if-te-0/5)# channel-group 100 mode active type standard %%Error: A switchport or a…
The correct answer is D. Switchport is configured on the interface. See the full explanation below for the reasoning.
Question
Referring to the exhibit, what is the cause of the error when applying a port channel to an interface? sw0(conf-if-te-0/5)# channel-group 100 mode active type standard %%Error: A switchport or a router port cannot be aggregated
Options
- AA routing protocol is configured in the port channel.
- BAccess mode is not supported with link aggregation.
- CSwitchport is configured in the port channel.
- DSwitchport is configured on the interface.
How the community answered
(61 responses)- A3% (2)
- B5% (3)
- C11% (7)
- D80% (49)
Community Discussion
No community discussion yet for this question.