Brocade
143-420 · Question #146
You have attached a host to a fabric. The host switch port shows as F_Port. You have zoned the new device, saved, and activated the new zoning information. The host is not able to communicate with…
The correct answer is D. On either switch in the exhibit, run the fcping command with the WWNs as the arguments. See the full explanation below for the reasoning.
Question
You have attached a host to a fabric. The host switch port shows as F_Port. You have zoned the new device, saved, and activated the new zoning information. The host is not able to communicate with the storage. How would you validate the zoning and FC communication end-to-end?
Exhibit
Options
- AOn switch FAB_A, run the islshow, followed by the portdportest commands; perform the same set
- BOn switch FAB_A, verify the entry in the name service for device 21:00:00:20:37:e1:33:40; verify
- COn switch FAB_B, verify the entry in the name service for device 10:00:00:00:c9:2a:b6:9e; verify
- DOn either switch in the exhibit, run the fcping command with the WWNs as the arguments.
How the community answered
(37 responses)- A3% (1)
- B8% (3)
- C5% (2)
- D84% (31)
Community Discussion
No community discussion yet for this question.