What is the remote port used for on a Riverbed hardware appliance?

The correct answer is B. IPMI "lights out" Remote control management. To configure the remote management port Physically connect the REMOTE port to the network. You cable the remote management port to network in the same manner as the Primary interface. Install the IPMItool on the client machine. * Assuming the IP address is 192.168.100.100, the…

Understand SteelHead Deployment and Initial Configuration

Question

Options

ARemote control using a modem or ISDN device
BIPMI "lights out" Remote control management
CExport of netflow statistics
DSteelFusion Edge device connection
EData store synchronization

How the community answered

(34 responses)

A
3% (1)
B
74% (25)
C
3% (1)
D
6% (2)
E
15% (5)

Explanation

To configure the remote management port * Physically connect the REMOTE port to the network. You cable the remote management port to network in the same manner as the Primary interface. * Install the IPMItool on the client machine. * Assuming the IP address is 192.168.100.100, the netmask is 255.255.255.0, and the default gateway is 192.168.100.1, assign an IP address to the remote management port. Etc.

Topics

#remote port#IPMI#out-of-band management#hardware appliance

Community Discussion

No community discussion yet for this question.

Full 101-01 Practice