Which report would you use to monitor disk utilization in the SteelHead management console user interface?

Question

Options

• AReports > Data Store Cost
• BReports > Data Store Disk Load
• CReports > Data Store Hit Rate
• DReports > Data Store Status

• A
  10% (3)
• B
  71% (22)
• C
  16% (5)
• D
  3% (1)

Explanation

The Data Store Disk Load report summarizes the data store disk load due to SDR-only as related to the benchmarked capacity of the data store. Consider any value under 100 as healthy. Any value higher than 100 might indicate disk pressure. When a value is consistently higher than 100, contact Riverbed Professional Services for guidance on reconfiguring the data store to alleviate The Data Store Disk Load report answers the following questions: * Is there any indication of disk pressure? * What is the disk load at different times of the day? Not A: The Data Store Cost report summarizes the relative cost of doing data store operations. The Data Store Cost report answers the following questions: * Is the data store load healthy? * Is there possible disk pressure? * What is the relative load at different times of the day? Not C: The Data Store Hit Rate report answers the following questions: * How much optimization is occurring? * How much optimization occurred through SDR hits? * How much data traversed the WAN without optimization? Not D: The Data Store Status report answers the following questions: * Is the synchronization connection active? * Is the Steelhead appliance in the Catch-up or Keep-up phase of data store synchronization? * What percentage of the data store is unused?

No community discussion yet for this question.